Abstract This paper proposes a new strategy for extending centrifugal compressor stall margin through shroud passive flow control placed at the impeller radial bend. Relative to the usual leading-edge location, the radial bend presents fewer geometrical constraints for flow control devices and allows them to have potentially more impact on low-momentum flow structures that lead to stall. Two centrifugal compressors with fishtail pipe diffusers are chosen for study: a high-speed transonic design exhibiting diffuser stall and a low-subsonic design with exducer stall. Four passive flow control techniques placed on the impeller shroud at the radial bend are evaluated for each compressor, in terms of stall margin improvement and efficiency penalty at design mass flow, using unsteady RANS CFD simulations. These are circumferential groove, slots, impeller recirculation pipe and diffuser-impeller recirculation pipe. The results indicate that passive flow control at the impeller shroud radial bend can be significantly more effective than at the impeller leading edge. For each compressor, the flow mechanisms associated with stall initiation and its delay by the most effective studied flow control technique as well as the associated efficiency penalty are elucidated. The findings indicate that techniques having flow injection with high spanwise penetration and low relative streamwise momentum are most effective for delaying diffuser stall, while the opposite applies to exducer stall. The design point efficiency penalty is due to mixing/shear losses from the jet-in-cross flow phenomenon in the impeller and shear losses from flow redistribution in the diffuser.