This paper looks at all aspects of developing a robotic arm and hand that consists of five fingers which is able to imitate human movements. The imitation ability, accuracy and factors affecting both points are studied. A project like this requires the interplay of various electrical components to achieve the desired results.The prototype constructed measured the controller’s movements of the fingers with the help of flex sensors. The movements in the elbow and wrist however were measured with the help of potentiometers. The flex sensors and potentiometers were connected to an Arduino Mega which then sent the values with the help of a transmitter. The robotic arm consists of an Arduino Uno, seven servomotors and a receiver that reads the messages sent from the transmitter. All values were converted into degrees that rotated the motor axles accordingly. The prototype produced positive results, showing that it was able to copy all movements done by the controller. Tests were conducted to study the accuracy and imitationability. The conclusion was that the factors affecting imitation and accuracy were mostly connected to the weight of the robot and the design of the hand. ; Denna uppsats behandlar olika aspekter i utvecklingen av en robotarm vars gripdon är en hand med fem fingrar, med syfte att kunna imitera mänskliga rörelser. Imitationsförmågan, noggrannheten samt vilka faktorer som påverkar dessa studeras. För att uppnå ett önskvärt resultat har det krävts styrning och samverkan mellan olika elektroniska komponenter. I prototypen som presenteras mättes fingrarnas rörelsemed hjälp av flexsensorer samt rörelsen i armbåge och handleden med hjälp av vridpotentiometrar. Flexsensorerna och potentiometrarna var anslutna till en Arduino Mega vars värden skickades med hjälp av en sändare. Elektronikkomponenterna som användes i robotarmen var en ArduinoUno, sju servomotorer och en mottagare, vars funktion var att läsa av meddelanden som skickades från sändaren. Alla värden omvandlades till grader och motoraxlarna ...