Suche

Sie sind hier: Homepage > Suche

Auswahl aufheben

1–50 von 115 Ergebnissen

Treffer gruppieren

Clamping performance of fastener in windshield wiper assembly using theoretical and experimental methods

Chung, J. H. / Lee, K. H. / Lee, C. -H. et al. | Springer Verlag | 2016

Experimental study on macroscopic spray characteristics after impingement in a slit-type GDI injector

Lee, C. H. / Lee, K. H. | Springer Verlag | 2008

Effects of injection parameters on the spray characteristics of swirl and slit injectors using the Mie-scattering method

Lee, C. H. / Lee, K. H. / Lim, K. B. | Springer Verlag | 2010

Integration of GPS and monocular vision for land vehicle navigation in urban area

Lim, J. H. / Choi, K. H. / Cho, J. et al. | Springer Verlag | 2017

Active coolant control strategies in automotive engines

Kim, K. B. / Choi, K. W. / Lee, K. H. et al. | Springer Verlag | 2010

Vibration reduction of H/Shaft using an electromagnetic damper with mode change

Lee, K. H. / Bak, J. H. / Park, J. -L. et al. | Springer Verlag | 2017

Examination of nanoparticles from gasoline direct-injection (GDI) engines using transmission electron microscopy (TEM)

Seong, H. / Choi, S. / Lee, K. | Springer Verlag | 2014

Traffic-balancing algorithm for can systems with dual communication channels to enhance the network capacity

Lee, S. / Lee, D. H. / Kim, M. H. et al. | Springer Verlag | 2010

Active yaw control for handling performance improvement by using traction force

Kim, H. / Lee, S. / Hedrick, J. K. | Springer Verlag | 2015

A novel adaptive algorithm with an IIR filter and a variable step size for active noise control in a short duct

Park, J. H. / Lee, S. K. | Springer Verlag | 2012

Simplified dynamics model for axial force in tripod constant velocity joint

Cai, Q. -C. / Lee, K. -H. / Song, W. -L. et al. | Springer Verlag | 2012

Development of a hardware in the loop simulation system for electric power steering in vehicles

Lee, M. H. / Lee, H. M. / Lee, K. S. et al. | Springer Verlag | 2011

Development of discomfort evaluation method for car ingress motion

Kim, S. H. / Lee, K. | Springer Verlag | 2009

Analysis of the effect of cold start on fuel economy of gasoline automatic transmission vehicle

Lee, Y. K. / Park, J. I. / Lee, J. H. | Springer Verlag | 2014

Expanding transmission capacity of can systems using dual communication channels with kalman prediction

Kim, M. H. / Lee, S. / Lee, K. C. | Springer Verlag | 2012

Improvement of long-term lives of rubber gaskets of polyacrylate (ACM) by employing carboxyl cure sites

Kwon, Y. -D. / Lee, K. -S. / Jun, S. -H. et al. | Springer Verlag | 2014

Node-based scheduling method for easy migration from CAN to FlexRay in in-vehicle networking systems

Kim, M. H. / Lee, S. / Lee, K. C. | Springer Verlag | 2014

Effect of a 2-stage injection strategy on the combustion and flame characteristics in a PCCI engine

Kim, Y. J. / Kim, K. B. / Lee, K. H. | Springer Verlag | 2011

Viable combined cycle design for automotive applications

Kim, K. -B. / Choi, K. -W. / Lee, K. -H. | Springer Verlag | 2012

Structural optimization of a circumferential friction disk brake with consideration of thermoelastic instability

Song, B. -C. / Lee, K. -H. | Springer Verlag | 2009

Investigation on the flow and heat transfer characteristics of diesel engine EGR coolers

Kim, H. -M. / Park, S. -K. / Choi, K. -S. et al. | Springer Verlag | 2008

Requirement-based testing of an automotive ECU considering the behavior of the vehicle

Lee, S. H. / Park, T. W. / Chung, K. H. et al. | Springer Verlag | 2011

Auto-ignition and micro-explosion behaviors of droplet arrays of water-in-fuel emulsion

Jeong, I. C. / Lee, K. H. | Springer Verlag | 2008

Development of a new evaluating method for deciding a representative smoke emission of diesel vehicle driven with KD147 mode

Park, K. Y. / Lee, C. H. | Springer Verlag | 2015

High speed driving stability of passenger car under crosswind effects

Kee, J. D. / Rho, J. H. / Kim, K. H. et al. | Springer Verlag | 2014

Analysis of a large injection-molded body using knowledge-based flow process technology

Kwac, L. K. / Lee, H. K. / Kim, H. G. | Springer Verlag | 2012

Effects of FTP-75 mode vehicle fuel economy improvement due to types of power steering system

Wi, H. S. / Lee, Y. K. / Park, J. I. et al. | Springer Verlag | 2009

Measurement of roof deformation caused by vehicle rollover

Yoon, H. -S. / Lee, K. -T. / Ahn, S. -H. | Springer Verlag | 2013

Lane-following method for high speed autonomous vehicles

Lee, K. B. / Han, M. H. | Springer Verlag | 2008

Experimental investigation of nozzle cavitating flow characteristics for diesel and biodiesel fuels

Suh, H. K. / Park, S. H. / Lee, C. S. | Springer Verlag | 2008

Life estimation of hot press forming die by using interface heat transfer coefficient obtained from inverse analysis

Kim, D. Y. / Kim, H. Y. / Lee, S. H. et al. | Springer Verlag | 2015

Experiments and thermal-electrical analysis of buss bar and relay assemblies in junction blocks

Hwang, S. Y. / Lee, J. H. / Visuwanathan, K. K. et al. | Springer Verlag | 2013

Technology analysis and low-cost design of automotive radar for adaptive cruise control system

Jeong, S. H. / Lee, J. E. / Choi, S. U. et al. | Springer Verlag | 2012

Design of Integrated Chassis Control logics for AFS and ESP

Hwang, T. H. / Park, K. / Heo, S. -J. et al. | Springer Verlag | 2008

Effect of injection condition and swirl on D.I. diesel combustion in a transparent engine system

Kim, H. M. / Cho, W. J. / Lee, K. H. | Springer Verlag | 2008

Development of an autonomous braking system using the predicted stopping distance

Lee, D. H. / Kim, S. K. / Kim, C. S. et al. | Springer Verlag | 2014

Fatigue and buckling analysis of automotive components considering forming and welding effects

Lee, K. T. / Park, C. S. / Kim, H. Y. | Springer Verlag | 2016

Light-weight design of automotive suspension link based on design of experiment

Park, J. H. / Kim, K. J. / Lee, J. W. et al. | Springer Verlag | 2015

Quasi-dimensional analysis of combustion, emissions and knocking in a homogeneous GDI engine

Lee, J. / Lee, Y. / Huh, K. Y. et al. | Springer Verlag | 2015

Reduction of emissions with propane addition to a diesel engine

Lee, J. / Choi, S. / Kim, H. et al. | Springer Verlag | 2013

Effects of gasoline, diesel, LPG, and low-carbon fuels and various certification modes on nanoparticle emission characteristics in light-duty vehicles

Myung, C. L. / Lee, H. / Choi, K. et al. | Springer Verlag | 2009

Piston-temperature measuring system using electromagnetic induction with verification by a telemetry system

Lee, H. H. / Bang, H. W. / Kauh, S. K. et al. | Springer Verlag | 2011

Analytical study of pressure pulsation characteristics according to the geometries of the fuel rail of an MPI engine

Heo, H. S. / Bae, S. J. / Lee, H. K. et al. | Springer Verlag | 2012

Effect of tumble-home on roof strength of a vehicle

Seo, J. H. / Lee, E. D. / Lee, J. W. et al. | Springer Verlag | 2016

Design and implementation of a new clamping force estimator in Electro-Mechanical Brake systems

Ki, Y. H. / Lee, K. J. / Cheon, J. S. et al. | Springer Verlag | 2013

Development of a path planning system using mean shift algorithm for driver assistance

Hwang, J. / Lee, D. / Huh, K. et al. | Springer Verlag | 2011

Active noise control in a duct system based on a frequency-estimation algorithm and the FX-LMS algorithm

Kim, E. Y. / Kim, B. H. / Lee, S. K. | Springer Verlag | 2013

Sheet metal forming simulation considering die deformation

Choi, K. Y. / Lee, M. G. / Kim, H. Y. | Springer Verlag | 2013

Laser irradiated bending characteristics of the ultra-high strength steel sheets

Song, J. H. / Lee, G. A. / Jung, K. H. et al. | Springer Verlag | 2015

Vehicle interior noise model based on a power law

Kook, H. -S. / Lee, D. / Ih, K. -D. | Springer Verlag | 2011

Erscheinungsjahr

Medientyp

Datenquelle

Autor

Fach

Format

Lizenz

Sprache