81–100 von 139 Ergebnissen
|

    AIR FLOW Through Intake Valves

    TAYLOR, C. F. / HUNTER, D. U. / TAYLOR, E. S. et al. | SAE Technical Papers | 1942

    Cervical Spine Injury Mechanisms

    Huelke, D. E. / Montalvo, F. / Nusholtz, G. S. et al. | SAE Technical Papers | 1983

    Experimental and Numerical Analysis of Engine Gas Exchange, Combustion and Heat Transfer during Warm-Up

    Boretti, A. A. / Lodi, F. / Will, F. et al. | SAE Technical Papers | 2008

    Painted EPDM for Body Components

    Kruse, D. F. / Spenadel, L. / Banks, S. A. et al. | SAE Technical Papers | 1974

    High Efficiency Pathogen Collection and Rapid Detection of Surface Microbes

    Pyle, B. H. / Bradley, B. J. / Saddler, F. S. et al. | SAE Technical Papers | 2002

    Hydrogen Blended Natural Gas Operation of a Heavy Duty Turbocharged Lean Burn Spark Ignition Engine

    Nedelcu, C. / Lynch, F. / Dixon, G. et al. | SAE Technical Papers | 2004

    The Measurement of Lubricating Oil Combustion Efficiency Using Diesel Particulate Analysis

    Ahamed, F. M. / Andrews, G. E. / Elamir, I. E. et al. | SAE Technical Papers | 1998

    USCAR Traction Test Methodology for Traction-CVT Fluids

    McWatt, D. G. / Caracciolo, F. / Wedeven, G. G. et al. | SAE Technical Papers | 2002

    Experience with DIESEL LUBRICATING OILS

    Gordon, M. S. / Timberlake, T. G. / Robbins, W. E. et al. | SAE Technical Papers | 1948

    Investigation of Compression Ratio Effect on Wet Ethanol Use in Spark Ignition Engines

    Golke, Diego / Pereira, Fernando M. / Enzweiler, Henrique J. et al. | SAE Technical Papers | 2017

    How to Set Quality Improvement Goals

    Gruska, G. F. / Bajaria, H. J. / Mashigian, H. S. et al. | SAE Technical Papers | 1980

    Immobilized Cell Bioreactors for Water Reclamation: Process Stability and Effect of Reactor Design

    Dismer, Berit G. / Zinger, Edward F. / Petrie, Glenn E. et al. | SAE Technical Papers | 1992

    Exhaust Emission Levels of In-Service Vehicles - Comparison of 1970 and 1971 Surveys

    Gower, B. G. / Coleman, E. C. / Voelz, F. L. et al. | SAE Technical Papers | 1972

    Collaborative Engineering Methods for Radiation Shield Design

    Johns, B. D. / Cucinotta, F. A. / Badavi, F. F. et al. | SAE Technical Papers | 2001

    CFD Analysis of Injection Timing Influence on Mixture Preparation in a PFI Motorcycle Engine

    Grimaldi, C. N. / Brusiani, F. / Bianchi, G. M. et al. | SAE Technical Papers | 2006

    Lubricants As Related to Gear Tooth Surface Failure Problems

    Younger, F. C. / Lichtman, L. / Daniels, N. H. G. et al. | SAE Technical Papers | 1962

    Significant Structural Design And Fabrication Developments - A Panel Discussion

    MAGEE, F. L. / MOTHERWELL, G. W. / WOLFE, K. B. et al. | SAE Technical Papers | 1949