121–140 von 5,723 Ergebnissen
|

Ihre Suche:
title:"International series in operations research

    Variability in Hydrocarbon Speciation Measurements at Low Emission (ULEV) Levels

    Chladek, Ema / Chase, Richard E. / Strand, Vicki L. et al. | SAE Technical Papers | 1995
    As vehicle tailpipe emission levels decrease with improvements in emission control technology and reformulation of gasolines, exhaust ...

    Valve Flow Coefficients under Engine Operation Conditions: Piston Influence and Flow Pulsation

    Bargende, Michael / Grill, Michael / Fasse, Sven | SAE Technical Papers | 2019
    in 0D/1D engine simulation. Valve flow coefficients are normally determined at a stationary flow test bench, separately for intake and ...

    Value-Based Decision Making at the SAE Section Level: A South Florida Section Case Study

    Breneman, Jim / McElroy, Robert C. / Warwick, Tom | SAE Technical Papers | 1997
    execution of the programs for an SAE Section year in the South Florida Section. The SAE South Florida Section utilized the concepts of Value ...
    Schlagwörter: Research and development

    VALIDATION OF HUMAN BODY MODELING FOR DYNAMIC SIMULATION

    ROBBINS, D.H. / BECKER, J.M. / BENNETT, R.O. | SAE Technical Papers | 1977
    research, development, and design tools among the various groups involved in the field of automotive safety has been limited because of a lack of ...
    Schlagwörter: Research and development

    Validation of Dynamic Force Predicted by Simulation for Hydraulic Dampers Used on EHV Electric Circuit Breaker

    Chavan, Ketan / Saraf, M. R. / Mehendale, N. P. et al. | SAE Technical Papers | 2013
    actuator in lab. Load vs strain data was acquired and graphs were plotted. The same instrumented rod end was fitted on three different Hydraulic ...
    Verlag: Society of Automotive Engineers , The Automotive Research Association of India

    Validation of Computational Vehicle Windshield De-Icing Process

    Przekwas, A. J. / Lee, J.-G. / Sioshansi, M. et al. | SAE Technical Papers | 1994
    This study is a joint development project between Chrysler Corporation and CFD Research Corporation.The objective of this investigation was ...
    Schlagwörter: Research and development

    Validation and Instrumentation of a Small Modular Multi-Stage Axial Compressor for Ice Crystal Icing Research

    Chalmers, Jennifer / Neuteboom, Martin / Currie, Thomas | SAE Technical Papers | 2019
    use in altitude icing wind tunnels such as the NRC’s altitude icing wind tunnel (AIWT), research altitude test facility (RATFac.), and those ...

    Vacuum Die Casting Technology with True T6 Heat Treating Capability

    Nelson, Craig A. | SAE Technical Papers | 1994
    . This process was initiated by OMC Research and developed jointly with OMC Waukegan. The project began 1990 and was put into production in 1992 ...

    UV-Curable Primer-cum-Paint System for Mild Steels based on Sol-Gel Coating Technology

    Jyothirmayi, A. / Padmanabham, G. / Somaraju, K.R.C. et al. | SAE Technical Papers | 2009
    metals/steels. In this context, investigations were carried out on the mechanical and corrosion protection properties of UV-curable transparent ...
    Verlag: Society of Automotive Engineers , The Automotive Research Association of India

    Utilizing the Crushing Under Load Properties of Polypropylene and Polyethylene Honeycomb to Manage Crash Energy

    Porter, John H. | SAE Technical Papers | 1994
    passengers in motor vehicles. Determination of the load conditions and crash mechanisms has been the basis for a large amount of research and broken ...

    Utilization of Whole Catalyst X-Rays

    Fanick, E. Robert / Ruescher, Edward G. / Ingalls, Melvin N. et al. | SAE Technical Papers | 1985
    in both research and after-market used catalyst screening are also discussed. ...
    Schlagwörter: Research and development

    Utilization of Virtual Environments for Astronaut Crew Training

    Smith, J. D. / Savage, P. D. | SAE Technical Papers | 2000
    The development of virtual environment technology at NASA Ames Research Center and other research institutions has created opportunities ...

    Utilization of Recovered Inorganic Nutrients From Composted Fresh or Oven-Dried Inedible Plant Biomass for Supporting Growth of Wheat in a BLSS

    Garland, Jay L. / Judkins, Jennifer E. / Hummerick, Mary E. et al. | SAE Technical Papers | 2001
    The use of composting technology is attractive to NASA’s Bioregenerative Life Support System (BLSS) research because it offers a potential ...

    Utilization of Knowledge Based Utilities for Streamlining the Characterization Procedure of Acoustic Material Properties

    Thipse, Y. S. | SAE Technical Papers | 2014
    , classification, report generation and most importantly, storage of such innumerable material properties in a structured manner to facilitate ease of ...
    Verlag: Society of Automotive Engineers , The Automotive Research Association of India

    U.S./Russian EVA Status

    Abramov, Isaac P. / Yuzov, Nikolai / Tsygankov, Oleg S. et al. | SAE Technical Papers | 1997
    U.S. and Russian cooperation in the International Space Station (ISS) has been ongoing since the end of 1993. Joint agreements related to ...

    Using Statistical Energy Analysis to Optimize Sound Package for Realistic Load Cases

    Caillet, Arnaud / März, Christian / Venor, Joseph et al. | SAE Technical Papers | 2020
    the classical airborne analysis usually done with SEA. The sound package was also detailed in the model to allow further optimization and ...
    Schlagwörter: Research and development

    Using Smart MOSFET Technology in Real Automotive Applications

    Franco, Rodrigo | SAE Technical Papers | 2012
    reduction.Nowadays there are many types of automotive MOSFET offered in the market with integrated logic circuit able to provide enhanced functions to ...
    Schlagwörter: Research and development

    Using Simulation for Research - and Using Research to Develop Valid Simulation Techniques

    Brissenden, Roy F. | SAE Technical Papers | 1967
    discussed extensively, and respresentative fixed- and moving-base research simulators in use at the Langley Research Center are presented to ...
    Schlagwörter: Research and development

    Using Neural Network for Springback Minimization in a Channel Forming Process

    Cao, J. / Ruffini, R. | SAE Technical Papers | 1998
    -linear system in a predictive way. For demonstration, an aluminum channel forming process is considered in this work. Our previous research [1 ...
    Schlagwörter: Research and development

    Using Multi-Rate Filter Banks to Detect Internal Combustion Engine Knock

    Karlström, Anders / Burgdorf, Klaas | SAE Technical Papers | 1997
    The wavelet transform is used in the analysis of the cylinder pressure trace and the ionic current trace of a knocking, single-cylinder ...