Ihre Suche:
journal:(International Journal of Operations
Meinten Sie:
+journal:(international journal of operation
Advance of beta titanium alloy TIMETAL(registered trademark) LCB in automotive spring applications
|
Tema Archiv
| 2006
readily be fed into CNC spring winding machines used for steel wires without any major changes or extra operations. LCB suspension springs have ...
Aircraft control surface deflection using RBF-based mesh deformation
|
Tema Archiv
| 2011
sites are distributed on its faces and the evaluation is performed in the auxiliary geometry exclusively. Since the number of operations for ...
Aircraft life management using crack initiation and crack growth models - P-3C Aircraft experience
|
Tema Archiv
| 2007
management. The first section of the paper discusses general fleet life assessment methods followed by a description of traditional US Navy method of ...
Schlagwörter:
USA (United States of America)
|
Tema Archiv
| 2011
rig in rolling-sliding motion. Three different slips representative of actual traction and braking operations have been considered in the ...
Analysis of a hydrogen station roll-out strategy to introduce hydrogen vehicles in Andalusia
|
Tema Archiv
| 2014
The issue of the distribution of a sufficient infrastructure of hydrogen fueling stations to enable meeting of the initial demand and to ...
Schlagwörter:
Operations Research
|
Tema Archiv
| 2014
in the transverse direction. Weather- vaning is the concept of making the heading angle of the DP vessel head toward (or sway from) the ...
A parametric study of the lubrication transport mechanism at the rail-wheel interface
|
Tema Archiv
| 1996
This paper presents the results of an ongoing investigation on Conrail of ways to improve the transport mechanism at the wheel-rail ...
A plan for 21st century land transport
|
Tema Archiv
| 2004
alteration and coastal damage will be manifest. The point is to dramatically reduce CO2, a by-product of internal combustion engine operations, as ...
|
Tema Archiv
| 2011
. Comparisons between the new and the original criterion are carried out and show good agreement for the studied cases of tangent track operations. By ...
|
Tema Archiv
| 2014
US crushed stone operations. The purpose was to: (1) evaluate factors such as load/no-load conditions, speed, load capacity, vehicle age, and ...
|
Tema Archiv
| 2003
. Requirements concerning high-evolution rates of hydrogen or high-power densities for practical fuel-cell vehicle operations would be fulfilled enough ...
Curtains on board tanker for preventing spilt oil diffusion
|
Tema Archiv
| 1998
Oil pollution caused by tanker accidents is increasingly becoming a serious public issue. Even if a large quantity of oil spills from the ...
Design of high-speed planing hulls for the improvement of resistance and seakeeping performance
|
Tema Archiv
| 2013
High-speed vessels require good resistance and seakeeping performance for safe operations in rough seas. The resistance and seakeeping ...
Development and application of reduced-order modeling procedures for subsurface flow simulation
|
Tema Archiv
| 2009
The optimization of subsurface flow processes is important for many applications, including oil field operations and the geological storage ...
Development of the manufacture of complex composite panels
|
Tema Archiv
| 2011
Within this paper the difficulties in automating the manufacture of conventional sandwich panels used as secondary structures on an ...
|
Tema Archiv
| 2014
various modes of operations. It also includes the dynamic response of hydropneumatic accumulator, prime mover, and system output speed. Further ...
Effect of head wear and lateral forces on underhead radius crack propagation
|
Tema Archiv
| 2014
This paper investigated the effect of rail head wear (HW) and lateral forces on underhead radius stress conditions and resulting stress ...
Elasto-plastic fracture properties of an all-aluminum gas cylinder with different cracks
|
Tema Archiv
| 1998
All-aluminum cylinders are used for on-board storage of compressed natural gas in vehicles. Besides being subjected to the maximum fill ...
Fatigue strength analysis of welded joints in closed steel sections in rail vehicles
|
Tema Archiv
| 2011
residual stresses in the area of weld toe. Thus, the stress relieving and the blast cleaning operations increase the fatigue strength behaviour of ...
|
Tema Archiv
| 2014
The tribological properties of a copper matrix composite (Cu-MMC) for use in spacecraft rendezvous and docking operations were investigated ...
Ergebnisse anzeigen