search-head

Sie sind hier: Homepage >  Suche

Aufsatz (Zeitschrift)   Medizintechnik   Chemische und Umwelttechnik   Werkstoffkunde   Auswahl aufheben
1–20 von 172 Ergebnissen
|
Sortieren:

    Accelerated aging versus realistic aging in aerospace composite materials. I. The chemistry of thermal aging in a low-temperature-cure epoxy composite

    Dao, B. / Hodgkin, J. / Krstina, J. et al. | Tema Archiv | 2006
    , 120 C, 170 C, and 200 C (in air) and the changes to the chemical and physicochemical structure of the composite are analyzed by a range of ...

    A chemically informed, control-oriented model of a three-way catalytic converter

    Soumelldis, M.I. / Stobart, R.K. / Jackson, R.A. | Tema Archiv | 2007
    Chemical activity inside a three-way catalytic converter (TWC) is highly complex and usually is not taken into account when developing TWC ...

    A comparison of tailpipe, dilution tunnel, and wind tunnel data in measuring motor vehicle PM

    Maricq, M.M. / Chase, R.E. / Xu, N. | Tema Archiv | 2001
    Comparison between particle size distributions recorded directly at the tailpipes of both diesel and gasoline vehicles and measurements ...

    A decontamination system for chemical weapons agents using a liquid solution on a solid sorbent

    Waysbort, Daniel / McGarvey, David J. / Creasy, William R. et al. | Tema Archiv | 2009
    A decontamination system for chemical warfare agents was developed and tested that combines a liquid decontamination reagent solution with ...

    Advanced reactor concept for complex hydrides: Hydrogen desorption at fuel cell relevant boundary conditions

    Bürger, I. / Luetto, C. / Linder, M. | Tema Archiv | 2014
    capacities. As hydrogen is bonded by a chemical reaction to the solid state storage material, it is just released when heat is provided. In an ...

    Aerothermodynamic Assessment of Spiked Configuration for Drag Reduction at Hypersonic Speeds

    Kumar, Shailendra / Kulkarni, Vinayak / Jammy, Satya Pramod | ASCE | 2020
    reduction effectiveness. In-house perfect gas and chemical nonequilibrium solvers were utilized. The analysis revealed that flow separation and ...
    Verlag: American Society of Civil Engineers

    A fundamental tribochemical study of the third body layer formed during automotive friction braking

    Wirth, A. / Eggleston, D. / Whitaker, R. | Tema Archiv | 1994
    The chemical nature of the transfer film (TF) or third body layer (TBL) formed at the friction interface during automotive friction braking ...

    Aging effect on thermal, mechanical and tribological behaviour of polymeric coatings used for pipeline application

    Guermazi, N. / Elleuch, K. / Ayedi, H.F. et al. | Tema Archiv | 2008
    physico-chemical, mechanical and tribological properties of this coating was undertaken. Firstly, sorption kinetic was studied through water ...

    Aluminothermic preparation of Hf-Ta and Nb-10Hf-1Ti alloys and their characterization

    Sharma, I.G. / Majumdar, S. / Chakraborty, S.P. et al. | Tema Archiv | 2003
    -reduction of the oxides of individual components. In the adopted process the heat generated from the chemical reactions, serves the function of ...

    A modern analytical toolbox: defect (W&D) studies of automotive coating systems, including depth profiling studies

    Adamsons, Karlis | Tema Archiv | 2012
    Chemical and microscopy measurement technologies have proven to be very powerful in our failure analysis efforts to detail composition and ...

    Analysis of the mass transfer controlled regime in automotive catalytic converters

    Santos, H. / Costa, M. | Tema Archiv | 2008
    This article concentrates on the analysis of the mass transfer controlled regime in automotive catalytic converters operating under real ...

    Analytical Study for the Effects of Chemical Reaction and Mass Transfer on Free Convective Flow Past a Vertical Isothermal Cone Surface

    Odda, S. N | Online Contents | 2015
    AbstractAn analytical study is presented for the effects of chemical reaction and mass transfer on the free convective flow of a viscous ...

      Analytical Study for the Effects of Chemical Reaction and Mass Transfer on Free Convective Flow Past a Vertical Isothermal Cone Surface

      Odda, S. N | Online Contents | 2016
      AbstractAn analytical study is presented for the effects of chemical reaction and mass transfer on the free convective flow of a viscous ...

    Analytical Study for the Effects of Chemical Reaction and Mass Transfer on Free Convective Flow Past a Vertical Isothermal Cone Surface

    Seddeek, M. A. / Odda, S. N. / Abdelmeguid, M. S. | ASCE | 2015

    An analytical study is presented for the effects of chemical reaction and mass transfer on the free convective

     ...
    Verlag: American Society of Civil Engineers

    An analysis of dielectric properties of synthetic ballast water at frequencies ranging from 300 to 3000 MHz

    Boldor, Dorin / Ortego, Jeffrey / Rusch, Kelly A. | Tema Archiv | 2008
    operations (extremely large volumes of water, efficiency at destroying macro and micro organisms, environmental issues associated with chemical ...

    An assessment of waste issues associated with the production of new, lightweight, fuel-efficient vehicles

    Tonn, B.E. / Schexnayder, S.M. / Peretz, J.H. et al. | Tema Archiv | 2003
    volumes, we pay particular attention to a subset of highly toxic chemical constituents in hazardous waste. The article also examines capacity in ...

    An experimental investigation on mechanical fatigue property of chemical starch-based ER fluids

    Lee, H.G. / Choi, S.B. / Kim, J.H. et al. | Tema Archiv | 2002
    In this work, mechanical fatigue properties of a chemical starch-based ER fluid are empirically investigated. To do this, a flow-mode type ...

    An overview of the polymer-to-metal direct-adhesion hybrid technologies for load-bearing automotive components

    Grujicic, M. / Sellappan, V. / Omar, M.A. et al. | Tema Archiv | 2008
    -scale polymer-to-metal mechanical interlocking; (b) in-coil or stamped-part pre-coating for enhanced adhesion; and (c) chemical modifications of ...

    Application of magnetoelastic technology of the measurement of stresses in rails for high-speed trains

    Xin, Qi / Ling, Hou Zhi / Long, Tian Jian | Tema Archiv | 2004
    is strongly dependent upon many characteristics, such as mechanical, physical, and chemical, of the material. Based on this effect, an ...

    Assessmant of risks posed by chemical industries - application of a new computer automated tool MAXCRED-III

    Khan, F.I. / Abbasi, S.A. | Tema Archiv | 1999
    The paper describes the application of a new computer automated tool, developed by the authors, in the risk analysis of a typical chemical ...

    ATMOSAT, a new measurement platform for air quality monitoring

    Heinsheimer, T.F. | Tema Archiv | 1977
    chemical measurements en route. The use of new high strength fabrics allows the construction of a balloon that contains its lifting gas (helium ...

Ergebnisse anzeigen
10 50

Suchergebnisse filtern