A novel configurable DC/DC converter architecture, to be integrated as hard macrocell in automotive embedded systems, is proposed in the paper. It aims at realizing an intelligent voltage regulator. With respect to the state of the art, the challenge is the integration into an automotive-qualified chip of several advanced features like dithering of switching frequency, nested control loops with both current and voltage feedback, asynchronous hysteretic control for low power mode, slope control of the power FET gate driver, and diagnostic block against out-of-range current or voltage or temperature conditions. Moreover, the converter macrocell can be connected to the in-vehicle digital network, exchanging with the main vehicle control unit status/diagnostic flags and commands. The proposed design can be configured to work both in step-up and step-down modes, to face a very wide operating input voltage range from 2.5 to 60 V and absolute range from −0.3 to 70 V. The main target is regulating all voltages required in the emerging hybrid/electric vehicles where, besides the conventional 12 V DC bus, also a 48 V DC bus is present. The proposed design supports also digital configurability of the output regulated voltage, through a programmable divider, and of the coefficients of the proportional-integrative controller inside the nested control loops. Fabricated in 0.35 μm CMOS technology, experimental measurements prove that the IC can operate in harsh automotive environments since it meets stringent requirements in terms of electrostatic discharge (ESD) protection, operating temperature range, out-of-range current, or voltage conditions
Hard macrocells for DC/DC converter in automotive embedded mechatronic systems
2017-01-01
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
DDC: | 629 |
Mechatronic systems in automotive electronics
British Library Conference Proceedings | 1995
|Mechatronic systems in automotive electronics
Tema Archiv | 1995
|Automotive mechatronic systems - General developments and examples
Tema Archiv | 2006
|Requirements for Mechatronic Systems in the Automotive Technology
British Library Conference Proceedings | 2004
|Mechatronic systems for automotive engine and chassis mounts
Tema Archiv | 2006
|